Reply to thread

That is probably what I'm going to do in the end. I'm just nervous about sanding the CC off...I've done A LOT of molding and casting, but this is my first CC. Have you sanded it quite a bit with the grit progression? I haven't done too much heavy sanding but I had metal fibers EVERYWHERE from rubbing it with wire wool for a couple hours :lol:.


Kody


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top