Reply to thread

Message

i think i'm going to leave it how it is right now. i think it adds a little bit of character to the helmet. like a weld line. the messed up part is that the spots where it's the smoothest over the seam are the spots where it's the most noticeable. i also want to incorporate the pitting that i couldn't sand out into the finished product. i'm thinking of it as weathering that i don't have to do.

[QUOTE="Mike M., post: 254091, member: 1634"] i think i'm going to leave it how it is right now. i think it adds a little bit of character to the helmet. like a weld line. the messed up part is that the spots where it's the smoothest over the seam are the spots where it's the most noticeable. i also want to incorporate the pitting that i couldn't sand out into the finished product. i'm thinking of it as weathering that i don't have to do. [/QUOTE]

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification