Reply to thread

I marked the place, where to position the KERR metal dental file.

[ATTACH]59156[/ATTACH][ATTACH]59157[/ATTACH]


This is the harness I´ll be using for my jetpack. It´s an older, used german "Tragegestell". The main belt will be raised to the chest and the back will get an hardfoam plate, where the aluminium bar for the jetpack clips will be connected. Also the straps, which will be connected to the jetpack hooks, will be fixed.

[ATTACH]59158[/ATTACH][ATTACH]59159[/ATTACH][ATTACH]59160[/ATTACH]


Now to the installation of the jetpack hooks and clips, wonderful products from "full metal fett". Thanks again, mate! :)


First I mounted the lower clips.

[ATTACH]59161[/ATTACH][ATTACH]59162[/ATTACH][ATTACH]59163[/ATTACH][ATTACH]59173[/ATTACH]


I bought an aluminium bar and cut it in the length, which will be mounted to the harness. After that I bend it, to match it to the curve of the jetpack.

[ATTACH]59164[/ATTACH][ATTACH]59165[/ATTACH][ATTACH]59166[/ATTACH][ATTACH]59167[/ATTACH]


Then the installation of the hooks followed. Therefore I measured the space between the slots of my back armor and angled the hooks a little bit like in this guide. [ATTACH]59168[/ATTACH]

[ATTACH]59169[/ATTACH][ATTACH]59170[/ATTACH][ATTACH]59171[/ATTACH][ATTACH]59172[/ATTACH]


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top