Reply to thread

Sunday update: worked on the fibreglas holster. Time for some strapping...


I used a heavy duty rubber band (is used for bikes), two N52 rare earth magnets (with holes for screws), a washer and a knob from an old jacket for the fron part. For the back two chicago screws and two washer.


[ATTACH]55956[/ATTACH][ATTACH]55957[/ATTACH][ATTACH]55958[/ATTACH][ATTACH]55959[/ATTACH][ATTACH]55960[/ATTACH][ATTACH]55961[/ATTACH][ATTACH]55962[/ATTACH][ATTACH]55963[/ATTACH][ATTACH]55964[/ATTACH][ATTACH]55965[/ATTACH][ATTACH]55966[/ATTACH][ATTACH]55967[/ATTACH][ATTACH]55968[/ATTACH]


I was so nervous drilling the holes and being afraid of breaking the fibreglas... I cut the rubber strap too long... ;) So I´ll fix that, after doing some padding with softfoam, to keep the sidearm scratching on the minor rough inside of the holster. :)


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top