Reply to thread

Message

I managed to rework the flamethrower today. Two holes I drilled on the backside of the flamethrower and on the left side of the gauntlet, where they will connect with screws. It was sanded, the holes and gaps were filled. Then some grey primer applied and some more filling done. Drilled a hole to each front part, to simulate the openings, where the "fuel" and "flame" will come out. After that it was painting and weathering time. I used red and black acryl paint and silver all brushed on. Hope you like the result.:cool
[ATTACH]44908[/ATTACH][ATTACH]44909[/ATTACH][ATTACH]44910[/ATTACH][ATTACH]44911[/ATTACH][ATTACH]44912[/ATTACH][ATTACH]44913[/ATTACH]

[QUOTE="Notlewis, post: 374996, member: 694"] I managed to rework the flamethrower today. Two holes I drilled on the backside of the flamethrower and on the left side of the gauntlet, where they will connect with screws. It was sanded, the holes and gaps were filled. Then some grey primer applied and some more filling done. Drilled a hole to each front part, to simulate the openings, where the "fuel" and "flame" will come out. After that it was painting and weathering time. I used red and black acryl paint and silver all brushed on. Hope you like the result.:cool [ATTACH]44908.vB[/ATTACH][ATTACH]44909.vB[/ATTACH][ATTACH]44910.vB[/ATTACH][ATTACH]44911.vB[/ATTACH][ATTACH]44912.vB[/ATTACH][ATTACH]44913.vB[/ATTACH] [/QUOTE]

This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification