Reply to thread

To secure the side parts, I use 3 screws for each side. The side parts are filled with hot glue, so the screws will stay in position. Now the side parts can easily be sticked to the knee armor.

[ATTACH]41932[/ATTACH][ATTACH]41933[/ATTACH][ATTACH]41934[/ATTACH][ATTACH]41935[/ATTACH][ATTACH]41936[/ATTACH][ATTACH]41937[/ATTACH][ATTACH]41938[/ATTACH]

Next step will be to smooth the edges and the side parts will be glued into position.


This thread is more than 2 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top