Reply to thread

I've had quite few different circuit boards and found this to be the closest. You are correct, it's not move accurate, but looks very close. The size of the chip I'm sure is correct.


If I could get hold of the correct chip I would make the board using it.


Thanks for the comments.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top