Reply to thread

Yeah i cut a slit in each corner of the eye slot and squeezed the mandibles together and bondoed them.

It should be wearable because the clay sculpt will go back out to the area where the mandibles would generally be.The reason i did this was because if I sculpted over them in the original postiton the helmet would have been to huge and out of proportion.


This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top