Reply to thread

Today the printing of my 3D parts have started finally! The rangefinder is complete! Respirators are on their way! I'll have them probably next week until then here's a picture of the finished parts:


[ATTACH=full]149585[/ATTACH]



Sent from a potato.


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top