Reply to thread

You can find those bondo products at wal-mart for sure in the automotive section.  Don't even waste your money on glazing putty. 

My helmet is extreamly sturdy.  I guess if I were to drop it some pieces might end up broken but that could be said for any helmet.  You can also go the route of bolting on pieces.

You have to remember to rough up the sides that will be glued together to ensure a good bond.


This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top