Reply to thread

Ok, here is a little "process" to get yall started, I just don't know how to seal it.


First, you cut 2" strips (all squares are 2"tall)


Next you cut the squares (width varies from 2" and less)


Then you punch the holes out, and spray dye to look like thus:


DO NOT** ADD REGULAR NEATSFOOT OIL LIKE THIS PIC. BIG MESS!!! UGH! Squares are too dark, lace is all crappy...


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top