Reply to thread

I just did this with a Klingon disruptor . What you want to do is coat your wood sculpt with sanding sealer . then the silicon can't get in to the grain of the wood to make it stick or pick up the grain to show in your cast later.


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top