Reply to thread

I think the camera distorded it a bit.  I don't see it as being to big of an issue when costructing the helmet.  Once the area is trimmed away and the new visor is placed in everything will line up straight.  I may go back and correct this before molding.  Thanks for the input.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top