Reply to thread

Yea its not a bad model! I was happy to find out it just barely fit on my resin printer. I printed his design and experimented for the first time doing a hollowed out resin print, so it's not too heavy. Just have a few drainage holes to fill on the sides. The same creator of that sonic beam stl also had a decent model of the survival knife so I printed that too. Both these items are a little shorter than my original tools so they will sit better/lower in the pockets.


[ATTACH=full]243941[/ATTACH]



I also began painting my EE-3. It's a full size 3D print kit from TraywickDesigns on etsy. I struggled getting the print lines cleaned up until I tried the UV resin technique that was recommended to me, brushing thin coats of the resin I use for my resin printer on and curing with a UV light. Never using bondo again! The side greeblies I resin printed from RafalFett's files. I airbrushed a base coat of satin black and then misted with a dark grey in areas for some depth.


[ATTACH=full]243942[/ATTACH]


This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top