Reply to thread

Message

How many are needed for each blaster and does anybody have a picture?

This is what I have so far. With the part so small, there are so air holes in it. They will need to be trimmed. The black on is just dyed black. The silver one's are cold cast .aluminum.

http://thewarrenfamily.homeip.net/~bill/StarWars/Boba/esb/blaster/

[QUOTE="asok, post: 84024, member: 213"] How many are needed for each blaster and does anybody have a picture? This is what I have so far. With the part so small, there are so air holes in it. They will need to be trimmed. The black on is just dyed black. The silver one's are cold cast .aluminum. [url]http://thewarrenfamily.homeip.net/~bill/StarWars/Boba/esb/blaster/[/url] [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification