Reply to thread

I am working on that part and hoping to get them made this weekend.  I had to go buy a machine to put the mold in a vacuum to try and get it to come out right.  The problem is that the part is very small.  Saturday is my day to do castings.


Asok


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top