Reply to thread

Hey guys/gals, it's time to start thinking about the backplate build. I want to make it scaled to work with my BKBT armor (thanks slavefive).

 

I have a few pics, but I'll take any reference pics any one has of the original backplate. You can post them here and/or send high res. pics to my email addy Lorenzo_Cruz1@msn.com .


I have clear ref. pics of the sides,top, and jp harness holes .... the only thing I haven't confirmed is the center of the back, so I don't know if it should be raised quite a bit like a JD back, or more level with the rest of the back area.


 Somebody once posted a really good pic of the backplate here, but I can't find it now.



Thanks,:thumbsup:

Cruzer


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top