Reply to thread

Message

The armor came with three shoulders, I didn't pay attention to which one I threw into the picture.

[ATTACH=full]201020[/ATTACH]

I played around with the chest display that I got from fettronics and noticed how big of a gap there is between the board and the armor. I'll have to look at more references. In an attempt to further sand the openings a bit wider, I got a case of the jimmy arms and put a gouge in the plastic.

[ATTACH=full]201023[/ATTACH]

[ATTACH]201021[/ATTACH][ATTACH]201022[/ATTACH]

[QUOTE="zemzero, post: 505071, member: 6568"] The armor came with three shoulders, I didn't pay attention to which one I threw into the picture. [ATTACH type="full"]201020[/ATTACH] I played around with the chest display that I got from fettronics and noticed how big of a gap there is between the board and the armor. I'll have to look at more references. In an attempt to further sand the openings a bit wider, I got a case of the jimmy arms and put a gouge in the plastic. [ATTACH type="full"]201023[/ATTACH] [ATTACH]201021[/ATTACH][ATTACH]201022[/ATTACH] [/QUOTE]

This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification