Reply to thread

Well I opened my Rubies Jango for Christmas, I couldn't wait to get started on it! So I opened my new dremel and I thought sanding off the copyright information would be a good start ( mistake one ). So I took the dremel and put on an attachment that I thought was a sander, I didn't bother to read the manual ( mistake 2 ). So then I go to " sand " the information, and I realize a second after I put the "sander" to my helmet that it really was the cutting disk ( DOH!, Mistake 3, Big mistake ). SO then I put on the real sander and did the rest of the information. I tried to make it look smooth but it has the Jagged look. Thank GOD I didn't cut through the helemt! SO those anyone know how to make the place where I butchered/sanded look smooth? I will post pics so you can get an idea. Help would be much appreciated


This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top