Reply to thread

Thanks BudaFett ! Wasn't too keen on a 3D printed kit at first because it takes a lot of time to sand and fill, but I'm pretty happy with the result. I still would like to replace the nozzle of the EE3 with a metal replica but I am not sure about the right place for getting one...


This thread is more than 11 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top