Reply to thread

Continuing the description of my WIP build with some soft parts.


Homemade flak vest made white chintz clothe.

I chose the groomets solution to attach the armor, but I add a jewelery pin with clutch back on the top of each shoulder part, because they dangled down.

Screws are just glued on the back of the armor pieces with Superglue 3 and sticked very hard, so no need for epoxy I guess...


Had to weathered it a bit...


[ATTACH=full]226308[/ATTACH][ATTACH=full]226310[/ATTACH]


Homemade neckseal and gloves made with the same fabric :


[ATTACH=full]226311[/ATTACH][ATTACH=full]226312[/ATTACH]


Cape is a rest from a previous Boba Fett costume I made ten years ago... I like the colors but the fabric may seems too light.

Think I will try to rip off and weather the edge and see I need to work on a new piece.


[ATTACH=full]226313[/ATTACH]


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top