Reply to thread

Very acceptable but from the experience of trooping with the 501st those 3d printed spikes won't last and will break pretty fast if you plan to troop in your kit. You should definitely upgrade to the metal ones and make sure you secure them really really well. I tore one of my spikes off during a troop catching it on a elevator opening.


This thread is more than 11 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top