Reply to thread

the set up I did, was really simple, a button cell battery, size 2025, and that will easily run 2 LEDs. I just wired them to a mercury switch, but you could do a circut board too for the strobing, just a little solder and you'd be set. Tight fit, but it will all fit, if I didn't hot glue my top down, I'd get a quick shot of it.


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top