Reply to thread

After many requests, especially from guys in the UK I have started to sculpt a jet pack. I will be posting my progress here and hopefully get some positive feedback and a few good tips.


I thought the best way to start was with the rocket and the best way to build the rocket was with a lathe. I also intend to make the top and bottom of the side cannisters and thrusters using the lathe. Here are the pictures so far.





This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top