Reply to thread

Message: <blockquote data-quote="GCNgamer128" data-source="post: 119908" data-attributes="member: 1126"><p>If you need metal etched, laser is about the only way you can go.  A straight cut will definately require a water jet, but a super powerful laser can hit through metal if you want.  Remember that metal is reflective and the ore will need to be covered in tape before cut though.</p></blockquote><p></p>

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification

Forums
Community
Prop Building Workshop
laser cutting/ photo etching