Reply to thread

Heres a little update: I cut the shin tools down to size. All I need to do to them now is paint and weather them. Thanks for the O.G. tool set MMcFett and thank you machine craft replicas for suppling the rods! Just curious, does ESB Boba need the 4th shin tool for 501st approval?

[ATTACH=full]189651[/ATTACH]


This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top