Knee Dart Dimensions

Thread starter crazyDewback
Start date Jun 30, 2003

crazyDewback

Guest

Jun 30, 2003

I would like to start machining some darts, but I need to get some hard numbers, especially the rough length of a dart. The rest I could draw off myself.

BTW... Anyone needs a set of darts? Just send me a message!

This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.