Knee Dart dimensions, Diameters? (for machining)


I'm going to be machining up a set or two of these knee darts for a buddy and I have some questions:

1. what is the preferred method of attaching these to the knee armor? A threaded screw hole in the back?

2. I need the diameters, and measurments of them so I can machine to accurate specs? Any one got this on hand to share?

3. is there a difference between ESB and ROTJ? I'm not a OT Fett expert, I'm more interested in Jango and that is where I've done my research..

sorry Badger, I keep meaning to measure my knee darts, but I keep forgetting. I gotta put it on the list of things to do!
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.