Reply to thread

I'm gonna have to disagree with you on that one. I can pull my knees straight and get that harsh undercut and still get them out of the mold no problem, been doing it for about a year now. I don't know why BM's pulling them like that...probably easier to get them off the mold would be my guess (if they are in fact plastic, I know that he's just started producing his new stuff in plastic...I've seen his FG one's and they're flared straight back if memory serves me correctly).

Here's mine -

[ATTACH=full]132283[/ATTACH]

[ATTACH=full]132284[/ATTACH]

[ATTACH=full]132285[/ATTACH]


But yes Tin, you should be able to hit them with a heat gun and get them to bend back some more...although I don't understand why that wasn't done BEFORE they were painted. I've never done that with a painted piece before. I would be extremely careful doing it that way if I was you. You could possibly ruin the paint, just a heads up. Good luck with it either way mate! :thumbsup:


This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top