Reply to thread

I'm still waiting to visit the shop again to mold the small parts, i.e. flamethrower box, ripcord housing, and left gauntlet hose end. Hopefully soon. The top and bottom halves are good to go, but I also need to create a rocket too. So maybe about another 2-3 weeks. I can take orders and start producing and mailing out the halves if you want to get started on that and then ship out the small pieces later.

 

Here's what I've got so far. These are fiberglass pulls from the mold, and it looks like fiberglass is going to be the best medium for me to work in. It takes a little more work but it makes them very durable...which is probably a good thing because of the wear and tear our kids will be putting them through.

 

Cruzer


[ATTACH=full]4758[/ATTACH]


[ATTACH=full]4759[/ATTACH]


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top