Reply to thread

chest plates, get the templates and then print them out the size u want. after that get a trashcan (see that thread) and make it OR get plastic sheet o styrine  (i know it as PVC sheets) and then cut it out on that useing a dremel tool or what yea got handy. Put in oven for a little on 250 then bend it to body


helmets i don;t make, so no clue there


This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top