Reply to thread

Message

Just another scratchbuilt

I still haven't really gotten around to the real smooth sanding and "bondoing", but there's more parts to create in any case.

I ended up purchasing a scope, but other than that, I haven't bought anything for it. The blaster is made from wood taken from a scrap pile outside a box factory, some pvc I didn't need for my jet pack project, and a heavily modified Pringles tube with a type of plastic silverish looking film. Still not really attached, and I might up replacing it with something better. And the scope is slightly sloped I just noticed.

I am currently trying to make the back piece of the chamber, with the hammer and that.

[ATTACH=full]6479[/ATTACH]

[QUOTE="Just another swede, post: 98135, member: 1284"] [b]Just another scratchbuilt[/b] I still haven't really gotten around to the real smooth sanding and "bondoing", but there's more parts to create in any case. I ended up purchasing a scope, but other than that, I haven't bought anything for it. The blaster is made from wood taken from a scrap pile outside a box factory, some pvc I didn't need for my jet pack project, and a heavily modified Pringles tube with a type of plastic silverish looking film. Still not really attached, and I might up replacing it with something better. And the scope is slightly sloped I just noticed. I am currently trying to make the back piece of the chamber, with the hammer and that. [ATTACH=full]6479[/ATTACH] [/QUOTE]

This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification