Reply to thread

Message

Most of it is foam board. The fuel tanks I reinforced with metal flashing. The two cone parts of the rocket are from plastic spray bottles I FOUND at work. The top of the rocket I made out of plaster. It cost me $2 for the plaster so I figured if I couln't make it work I wasn't out much. The base of the rocket was one of those Nerf rocket launchers. If any one needs help I can talk them through it but if I can figure it out from using the tutorial any one can. Not to menton that some one else could do so much better. It was my only real first attempt and was just trying to do it cheap as well as nice.

[QUOTE="SkylaFett, post: 71039, member: 621"] Most of it is foam board. The fuel tanks I reinforced with metal flashing. The two cone parts of the rocket are from plastic spray bottles I [B]FOUND[/B] at work. The top of the rocket I made out of plaster. It cost me $2 for the plaster so I figured if I couln't make it work I wasn't out much. The base of the rocket was one of those Nerf rocket launchers. If any one needs help I can talk them through it but if I can figure it out from using the tutorial any one can. Not to menton that some one else could do so much better. It was my only real first attempt and was just trying to do it cheap as well as nice. [/QUOTE]

This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification