Reply to thread

Ended up getting a refund from Wasted Fett for the helmet.


I have a BobaMaker Jango helmet fully finished on order, and may grab a dented Jango from MinuteFett when I have more cash.


Other update is I got my MinuteFett Cruzer mold gauntlets. Resin missile and top left gauntlet shell will need to be replaced due to some unrepairable air bubbles and MF will be sending replacements, but other than that the casts aren't bad at all assuming I don't find anything weird when I start to polish/sand the coldcast.


I'm hoping to have someone else assemble these since I'd have to buy a dremel and heat gun. I'm also not sure where to get the correct piano hinges since these don't seem to have a removeable pin or else I may not know how they work lol.


[ATTACH=full]203350[/ATTACH]


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top