Reply to thread

Having done lots of fiberglass work in the past, I can tell you that laying any kind of cloth in inside corners is difficult to try and get all of the air bubbles out. A quick fix would also be to whip up some 5 min epoxy and work into the hole. Still looks like a nice pack!


This thread is more than 4 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top