Reply to thread

Message

Great, look for to seeing it.

They are just like Boba Fett's, in fact I would say they are like the ESB version & being gray. Looks like there is the padded tackle twill on each finger & thumb & the outside of the hand. The rest of the glove would be in grey. There doesn't seem to be any padded parts on the inside of the fingers though.

It is very hard to tell due to this being a comic. I am basing a number of decisions on this costume base on being in the same era as Boba Fett & emulating that style more for a real world look.

Also did some work on the helmet got the dent filled in and filled in the Boba specific damage. Leveled the areas the ears sit & got the mounting holes drilled for them. Cleared out the key slot area & installed the button panel. Getting ready for some primer.

[ATTACH=full]48237[/ATTACH]

[ATTACH=full]48238[/ATTACH]

[ATTACH=full]48239[/ATTACH]

[ATTACH=full]48240[/ATTACH]

[ATTACH=full]48241[/ATTACH]

[ATTACH=full]48242[/ATTACH]

[ATTACH=full]48243[/ATTACH]

<blockquote data-quote="toolguy301" data-source="post: 394854">Great, look for to seeing it.They are just like Boba Fett&#039;s, in fact I would say they are like the ESB version &amp; being gray.&nbsp; Looks like there is the padded tackle twill on each finger &amp; thumb &amp; the outside of the hand.&nbsp; The rest of the glove would be in grey.&nbsp; There doesn&#039;t seem to be any padded parts on the inside of the fingers though.It is very hard to tell due to this being a comic.&nbsp; I am basing a number of decisions on this costume base on being in the same era as Boba Fett &amp; emulating that style more for a real world look.Also did some work on the helmet got the dent filled in and filled in the Boba specific damage.&nbsp; Leveled the areas the ears sit &amp; got the mounting holes drilled for them.&nbsp; Cleared out the key slot area &amp; installed the button panel.&nbsp; Getting ready for some primer.[ATTACH=full]48237[/ATTACH][ATTACH=full]48238[/ATTACH][ATTACH=full]48239[/ATTACH][ATTACH=full]48240[/ATTACH][ATTACH=full]48241[/ATTACH][ATTACH=full]48242[/ATTACH][ATTACH=full]48243[/ATTACH]</blockquote>

[QUOTE="toolguy301, post: 394854"] Great, look for to seeing it. They are just like Boba Fett's, in fact I would say they are like the ESB version & being gray. Looks like there is the padded tackle twill on each finger & thumb & the outside of the hand. The rest of the glove would be in grey. There doesn't seem to be any padded parts on the inside of the fingers though. It is very hard to tell due to this being a comic. I am basing a number of decisions on this costume base on being in the same era as Boba Fett & emulating that style more for a real world look. Also did some work on the helmet got the dent filled in and filled in the Boba specific damage. Leveled the areas the ears sit & got the mounting holes drilled for them. Cleared out the key slot area & installed the button panel. Getting ready for some primer. [ATTACH=full]48237[/ATTACH] [ATTACH=full]48238[/ATTACH] [ATTACH=full]48239[/ATTACH] [ATTACH=full]48240[/ATTACH] [ATTACH=full]48241[/ATTACH] [ATTACH=full]48242[/ATTACH] [ATTACH=full]48243[/ATTACH] [/QUOTE]

This thread is more than 7 months old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification