Reply to thread

I am working on a revised set of blueprints for the Westars, they are nearly ready for posting.


If anyone has used these to machine a blaster I wasn't informed.  I would like to see the results if someone does.


I have been collecting the materials and the tools to make my on set.  I still need to get some heavy bar stock for the muzzle.


Alan


This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top