Reply to thread

He's just that good of a bounty hunter....don't be hatin...


 You'd need an aluminum RF stalk to work properly with a servo wouldn't you?  I would think a resin one wouldnt hold up very well at the bolt point as the backing rod does not extend down into the circle....ask me how I know lol.


This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top