Reply to thread

The way that I have seen it done is to put 3 slots around the dart shaft one for each blade. Then use the JB weld to secure them.

 

If you check out at some of the reference pics with the broken blade you can see the slot.

 

Alan


This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top