Reply to thread

Thanks for the kind words guys!


Finally another update! Been busy on the blaster and lazy with the pics



here are the parts for the base of the grip, made from 8mm & 10mm flat bar, I shaped the curved piece by grinding and filing down some 10mm bar.



more than meets the eye

[ATTACH=full]117177[/ATTACH]

[ATTACH=full]117178[/ATTACH]


Fixed the barrel parts together, holding nice and strong they is!  :D


[ATTACH=full]117179[/ATTACH]


This part is fixed to the grip and then the barrel slide into place, I still need to fix the barrel to this part.


[ATTACH=full]117180[/ATTACH]

[ATTACH=full]117181[/ATTACH]


Picked up some really cheap brass thread bar to machine down into tube form for the internal brass barrel. Great score for 12 bucks!


[ATTACH=full]117182[/ATTACH]

[ATTACH=full]117183[/ATTACH]

[ATTACH=full]117184[/ATTACH]



I still managed to forget to upload the pics of both the blasters :angry( will have then up by tonight (goddamnit forgot the best pic!)


[ATTACH=full]117185[/ATTACH]


This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top