Reply to thread

Message

a few other things done now!

cut out the triggers and managed to get one of them filed and fitted to the grip

[ATTACH=full]117173[/ATTACH]

also got the triangle barrels cut out this arvo and managed to leave one at work

[ATTACH=full]117174[/ATTACH]

and here's a couple shots of the final progress so far, again just the one blaster.

[ATTACH=full]117175[/ATTACH]

[ATTACH=full]117176[/ATTACH]

and you can see the grips have now been shaped, must be over 6 hours of filing and sanding in those grips

[QUOTE="Werstrooper, post: 297210, member: 3759"] a few other things done now! cut out the triggers and managed to get one of them filed and fitted to the grip [ATTACH=full]117173[/ATTACH] also got the triangle barrels cut out this arvo and managed to leave one at work [ATTACH=full]117174[/ATTACH] and here's a couple shots of the final progress so far, again just the one blaster. [ATTACH=full]117175[/ATTACH] [ATTACH=full]117176[/ATTACH] and you can see the grips have now been shaped, must be over 6 hours of filing and sanding in those grips :( [/QUOTE]

This thread is more than 7 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification