Reply to thread

Message

<blockquote data-quote="jangomando" data-source="post: 493453" data-attributes="member: 9812">I have two sets of 3d print files for the gauntlets that I now have.I already printed the set on the right and been using them since but while on a troop this year (before the pandemic btw) the right gauntlet one broke and in thinking of reprinting the ones I have or go for the ones on thingiverse.I have attached a picture of my Jango cosplay from last October just to show the size of them The set on the right are from pinfaceI got them in 2017 as they were the only Jango fett files out there for the gauntlet and I modified them to make them more accurate but kept the scale the same and they fit me good enough well perfect really The ones of the left are from thingiverse one thing I noticed with these ones. the arm holes look to big and I know you scale to fit your arms but then the darts would not fit in the holes otherwise and theses have small details which my old files dont.Just wanted to see if anyone could measure there cold cast ones or take pictures of the arm holes so then I know to keep using my old files from pinface or the thingiverse filesThanks for the advise[ATTACH=full]188829[/ATTACH][ATTACH=full]188830[/ATTACH][ATTACH=full]188831[/ATTACH]</blockquote>

[QUOTE="jangomando, post: 493453, member: 9812"] I have two sets of 3d print files for the gauntlets that I now have. I already printed the set on the right and been using them since but while on a troop this year (before the pandemic btw) the right gauntlet one broke and in thinking of reprinting the ones I have or go for the ones on thingiverse. I have attached a picture of my Jango cosplay from last October just to show the size of them The set on the right are from pinface I got them in 2017 as they were the only Jango fett files out there for the gauntlet and I modified them to make them more accurate but kept the scale the same and they fit me good enough well perfect really The ones of the left are from thingiverse one thing I noticed with these ones. the arm holes look to big and I know you scale to fit your arms but then the darts would not fit in the holes otherwise and theses have small details which my old files dont. Just wanted to see if anyone could measure there cold cast ones or take pictures of the arm holes so then I know to keep using my old files from pinface or the thingiverse files Thanks for the advise [ATTACH type="full"]188829[/ATTACH][ATTACH type="full"]188830[/ATTACH][ATTACH type="full"]188831[/ATTACH] [/QUOTE]

Verification