Reply to thread

Thanks Raf! I used your paint templates to get this done. Couldn't have done it without you. When I started this project I didn't really know the difference. I was broke, and wanted a Fett Helmet, so went the 3D route. Studied your stencils/templates for countless hours. Eyeballed them best I could, and went after it. Now that I'm this far along and have absorbed more knowledge I'm thinking my helmet cast isn't up to what I feel it should be. You're right about the practice for sure. I bet I re-did those rear panels probably 7 times ha. It appears I have some work cut out for me. and possibly some more curse words to utter along the way with a new helmet lol.


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top