Reply to thread

I have a 3-D printed helmet I have painted on since last December. I never intended on building a full outfit, but now that I've gotten all the armor and I'm halfway through the armor painting process I'm wondering if this helmet could meet 501st approval standards. I know my kill stripes need painted and the back panels need to be "more green", rangefinder, ect, but I'm more so talking about the shape. Would it pass approval standards? Thanks for your help and info. [ATTACH=full]219891[/ATTACH][ATTACH=full]219892[/ATTACH][ATTACH=full]219893[/ATTACH][ATTACH=full]219894[/ATTACH]


This thread is more than 3 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top