Reply to thread

Biomechaniod56....naw it's an off white. But I used my dremel with a really small bit and got the vents drilled out. Then I used a cutting wheel to cut the top off and then drilled a hole thru the middle of the long cylindar to run the wires thru. All I got to do now is paint it and glue the top back on. Won't look as clean as a reall metal one but should be good until I can afford one.


This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top