Reply to thread

I also built 2 AprilStorm EE-3's and used glazing putty on the larger areas and then lightly sanded once dry.  Used high build primer afterwards and then paint.   For mine, I added grips (found on ebay cheap) and tried to recreate the "block" on the brace using JB SteelStick.   One came out better than the other.  Here are some pics- still need to make it more silvery though.


This thread is more than 1 year old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top