Reply to thread

Here are my *VERY ROUGH* turned out wrist darts.  As I stated, they are not 100% accurate, as the groove in the point is too wide. I didn't have a small enough cutting bit. I also have to even out and grind down the middle section, and the bottom ring arbelow the point. not to mention that the points are all of a differing size, but that will be fixed on the bench grinder. Well, whaddaya think? (they're better than pen points or dremel bits, so that's a plus)


[ATTACH=full]3006[/ATTACH]


This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top