Reply to thread

I used a dremel to drill a pilot hole through mine.  It was molded into the helmet from Fettpride (FPH2).  Then increased the bit size to dremel the rest slowly to ensure a tight fit of the new Borden.


Then I epoxied it in place; this was all done before paint mind you...[ATTACH=full]185494[/ATTACH][ATTACH=full]185495[/ATTACH]


This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top