Reply to thread

Message

Seeking advice on how to install the borden connector.

I have a Bobamaker V4 ESB helmet and a MachineCraft borden replica. Unfortunately it is not a straight forward plug-and-play experience like I had hoped. The borden is a bit too large for the pre-made hole. Do I drill a larger hole? File down the borden? Slap on some duct tape and hope for the best? I don't want to ruin the paint job if possible.

Also: How much of of the borden should protrude once installed?
I've seen helmets with a borden just barely higher than the surface and helmets with almost 1 cm sticking out. Both looked wrong in my eyes.

[ATTACH=full]185490[/ATTACH]

[QUOTE="BH 32700, post: 490288, member: 9626"] Seeking advice on how to install the borden connector. I have a Bobamaker V4 ESB helmet and a MachineCraft borden replica. Unfortunately it is not a straight forward plug-and-play experience like I had hoped. The borden is a bit too large for the pre-made hole. Do I drill a larger hole? File down the borden? Slap on some duct tape and hope for the best? I don't want to ruin the paint job if possible. Also: How much of of the borden should protrude once installed? I've seen helmets with a borden just barely higher than the surface and helmets with almost 1 cm sticking out. Both looked wrong in my eyes. [ATTACH type="full" width="600px"]185490[/ATTACH] [/QUOTE]

This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification