Reply to thread

Message

I have done it two different ways. For a solid resin rangefinder cap, I drilled two small holes in the stalk & two holes in the cap. I inserted two pin nails that I cut down to keep everything aligned & epoxied it all together. Fot a hollow plastic top, I again drilled two small holes in both pieces & used two tiny screws to attach the plastic top. The aluminum is soft enough that it will thread if you turn the screws & then back them off to clear the threads a few times. It is hard to see it in the pic because the screws are black, but you get the idea.
http://ca.photos.yahoo.com/bc/vandkcenerini/vwp?.dir=/Jango+Fett+Photos&.dnm=inside+cap.jpg&.src=ph

[QUOTE="bigkidbiggertoys, post: 10122, member: 45"] I have done it two different ways. For a solid resin rangefinder cap, I drilled two small holes in the stalk & two holes in the cap. I inserted two pin nails that I cut down to keep everything aligned & epoxied it all together. Fot a hollow plastic top, I again drilled two small holes in both pieces & used two tiny screws to attach the plastic top. The aluminum is soft enough that it will thread if you turn the screws & then back them off to clear the threads a few times. It is hard to see it in the pic because the screws are black, but you get the idea. [url="http://ca.photos.yahoo.com/bc/vandkcenerini/vwp?.dir=/Jango+Fett+Photos&.dnm=inside+cap.jpg&.src=ph"]http://ca.photos.yahoo.com/bc/vandkcenerini/vwp?.dir=/Jango+Fett+Photos&.dnm=inside+cap.jpg&.src=ph[/url] [/QUOTE]

This thread is more than 22 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.

Verification